Ubiquiti power station 5 pdf




















Behind the user interface is a powerful firmware architecture which enables hi-performance outdoor multipoint networking.

Sporting an all-new design for improved usability, airOS v7 is the revolutionary operating system for Ubiquiti airMAX ac products. An independent processor on the PCBA powers a second, dedicated radio, which persistently analyzes the full 5 GHz spectrum and every received symbol to provide you with the most advanced RF analytics in the industry. Available with a firmware upgrade to airOS v7. This time-based graph shows the aggregate energy collected since the start of an AirView session, over time for each frequency.

The power of the energy in dBm is shown across the frequency span and one row is inserted in this graph every few seconds. It is important to note that the color of the energy designates its amplitude.

The darker colors Blues and darker shades mean very low to low energy levels at that frequency bin, whereas increasingly brighter colors ie: Green, Yellow, Orange, and finally Red designate increasingly higher energy levels at the specific frequency bin.

The Waterfall View's legend top-right corner provides a numerical guide associating the various colors to power levels dBm. The low end of that legend left is always adjusted with the calculated noise floor, and the high end right is set to the highest detected power level since the start of the session. This graph is ideal for determining the best channel to setup a WiFi network for optimal performance.

In the graph, each 2. This percentage is calculated by analyzing both the popularity and the strength of RF energy in that channel since the start of a AirView session. An installer could use this view to optimize a network installation by avoiding highly used channels and setting up new AP's on channels showing the least usage. This graph shows the aggregate energy collected since the start of an AirView Session.

The power of the energy in dBm is shown across the frequency span. Output Power: 20dBm. WPA Preshared Key: mys3curek3y Select Change but do not Apply settings yet. On the Network tab make the following changes.

Network Mode: Bridge. IP Address: Netmask: Gateway IP: On the System tab change the following. Administrator Username: admin Optional. In this tutorial, we will learn how to configure Powerbeam 5AC Point Point long distance configuration. To Point to Point configuration required 2 device required. Both devices will configure in a different mode. Local side device will configure an Access Point mode and Remote side device will configure as client mode. To configure in Power beam Ac in AP mode follow the steps below.

This network name will use to identify to connect your location b client device connection. Use a unique name so you can easily find it.



0コメント

  • 1000 / 1000